Contact Information
B.L. Wilcox & Associates
Mailing Address:
P.O. Box 829
Whittier CA 90608

Physical Address:
7615 Baldwin Place
Whittier CA 90602

Toll Free: 800-272-0643
Local: 562-693-2787
Fax: 562-693-5843
info@blwilcox.com

Saf-T-Pivot Dismount Section

The Saf-T-Pivot dismount section dramatically reduces the danger workers encounter when dismounting at the top of a ladder. It is designed to extend 4'6" above floor level. The climber can rotate completely around the rail in order to gain safe footing BEFORE detaching from the system. The sleeve can then be removed from the top of the rail if desired. Standard dismount sections are a minimum of 8', but longer custom lengths are available; call the factory for details. Recommended for every installation where a worker dismounts at the top of a climb. (Underground or downhole climbs require the Removable Extension Kit as described below.). A stainless steel Quick Release Pin is available to replace the standard stop bolt for convenience during frequent usage. The Quick Release Pin comes with a stainless steel lanyard.

Extension Kit components:

1. Standard Saf-T-Notch rail: 4-1/2' length (or 3-1/2' for uphole climbs) with top 2' of guide channel removed to permit Saf-T-Lok Sleeve to turn 360°.
2. Tie Down Rod with either standard top knob or Quick Release: Assembly with rod threaded at bottom to attach to the Mandril.
3. Mandril: Permanently installed 6" inside of the top section of the Saf-T-Notch rail. Solid bar machined on both ends, drilled and tapped at the top, to accept the Tie Down Rod. Secured in place with two cap screws.

Use of one extension rail at multiple sites will require the permanent installation of a Mandril on each ladder